Extracted text (via pymupdf)
2039 characters
1 '-6" 1'-3"OC J_ ---- 1 ·-0· ------- ¹----+---<_6 .375"Hole .875"Washer FIRE R 1 1/2" 1--0 LA N E ----------.ii I NO PARKING BY ORDER OF THE FIRE MARSHAL ARS 15-1627 " ·•-·'.-. . -.· --· 1/2" 3/8" ■ I (:; -- +7'-0" ABOVE G RADE -+-----------t7 . , FHWA APPROVED BREAKAWAY INSTALLATION J] .LGRADE ® E1 Regulatory Panel Sign - FIRE LANE Scale: 1 1/2"=1'-0" G) .080 ALUMINUM, 1.5" RADIUS CORNERS (2) 3M 3930 WHITE H.I.P. TYPE IV RETRO REFLECTIVE SHEETING G) 3M 882N RED INK OR TRANSLUCENT 3M 1172 "RED" ELECTROCUT FILM OVER LA 0 N/A ® 3M 1160 GRAFFITI OVERLAY FILM APPLIED OVER FINISHED SIGN FACE @ INSTALLATION HARDWARE TO CLEAR GRAPHICS DRIVE RIVET Drive rivets provide the convenience of a one-piece fastener with effective tamper-resistant design and fast installation using only a hammer. HEX NUTS AND BOLTS Use of tamper resistant components is required for connection. 0 PREFERRED: ZINC COATEDTELESPAR QUICK-PUNCH SIGN POST IN FHWA APPRC BREAKAWAY INSTALLATION Qwik-Punch posts are made with 7 /16" knockouts, 1 "on the center, on all four! This feature allows workers in the field to quickly punch holes exactly where th, needed leaving the balance of the post with a smooth unbroken appearance. T posts offer the same telescoping action and easy installation as standard Telesp ALTERNATE - REQUIRES OUA APPROVAL: TELESPAR GALVANIZED PRE-PUNCHED SIGN POST IN FHWA APPROVED BREAKAWAY INSTALLATION Square posts with 7 /16" prepunched holes on 1 "centers MOUNTING HEIGHT Mounting height is measured from the road surface to the bottom of the sign. PRIMARY SIGN Use a minimum of 5 feet in: • Rural areas Use a minimum of 7 feet in: • Areas with parking or pedestrians • Urban, business, commercial, or residential areas • Areas where the view of the sign may be obstructed SUPPLEMENTAL PLAQUE OR SIGN Supplemental plaques or signs may be lower than the minimum mounting hei! the primary sign. Allow a minimum 1/2-inch gap between stacked signs so the: expand and contract.